How to Build Simple and Dense Walls


Knowing how to build a solid and sturdy wall is something that will always be useful. Whether you divide the larger space into 2 smaller buildings or build a new room and need to dump your wall, getting some hot wall building tricks on your sleeve is a great idea. Theoretically, building a wall does not seem so difficult – is it? After all, it’s just a vertical “wall” of material that extends from floor to ceiling. But you may find it easier said than done. I will guide you through the main steps of building harga mdf a simple and straight wall. For this example let’s say you want to build a dividing wall to make 2 rooms smaller than larger. Your first step is to determine where your wall will sit. There will be several factors that you should consider when determining this.

1. Find ground flooring so you can select the areas that are best supported from below. Your wall should have adequate floor support.

2. In the same way, you have to find an area where the ceiling has a ceiling or bundle where you can stick the top end of your buttons. There will be cases where there is not – or not enough – a substantial board over the anchor. For this, you must first install a wooden anchor to the ceiling that is the same width as your wall thick, along your front wall. It can be segmented into as many pieces as you want, but they just need to collectively reach the whole. You can then secure the wall studs to this board.

3. Windows. You must determine the best distribution of your windows – if any – so as to provide as much natural light as possible. There will be moments when there is only one window in your room and happens to be right in the middle of your longest wall. This may cause problems because it can sit in a prime location for your new wall. In this case you just need to choose which room will get the window and the others have to leave without.

4. Door. This is the most important step as far as what will determine the usefulness of your new room. If your original room has only one door and is located at the end – which often happens – I’m sure you agree with me that it’s not wise to just squeeze your room from the center of the right. This is when you can do 1 of 2 things. You can add a second door on your new wall or you can create a “hallway” that leads to your second room in the back. Both have pros & cons. The former is ideal for “parent-child” situations, and the latter may be more ideal for situations that require less privacy.

Obviously, the first idea is far more space-saving because the hallway will take up a much larger area – not to mention making it a much more complicated project. But both have a place in various situations so it will be up to you to decide which one suits your goals better.

Ok, now that we’ve covered some key factors involved when determining WHERE to build your wall, let’s move on to the development stage. Assuming you have decided where you want to build your wall, you must “prepare the ground” for the building. If the floor has a carpet, linoleum, or other cover that has compressibility, you should remove it. Take a cutter knife or pasto, and cut what it takes to have the wall studs get in touch with the wooden floor. If the concrete floor then you should – like the ceiling – put a wooden stringer where the buttons can be screwed. The alternative to this is to use the “L” or “track” brackets – but I would advise the attacker. Using a stringer allows you to screw diagonally while you can not do this into concrete.

Remember that diagonal spots are not as strong as using a few “L” brackets or using aluminum or steel “tracks”. Then why I suggest to do diagonal screwing? Because it is cheaper and if done correctly, it is more than enough. (For people with bigger budgets, I recommend the track.) So how do you “do it right”? It is important that you use long and powerful screws, and quite a lot. Depending on the cross section and the interval between your buttons, how many screws you use may vary. But I would suggest at least 3 or 4 solid screw connections at each end of stud wall (top and bottom), where there is a 600mm interval from center to center. Pre drilling and balancing for the screw head is a good thing to do in this case. Do not use too little fat because this will me.